User`s guide

Chapter 32 IP Static Route Setup
LAN-Cell 2 User’s Guide
475
IP Subnet Mask Enter the IP subnet mask for this destination.
Gateway IP
Address
Enter the IP address of the gateway. The gateway is an immediate neighbor of your
LAN-Cell that will forward the packet to the destination. On the LAN, the gateway
must be a router on the same segment as your LAN-Cell; over the WAN, the
gateway must be the IP address of one of the remote nodes.
Metric Enter a number from 1 to 15 to set this route’s priority among the LAN-Cell’s routes
(see Section on page 92). The smaller the number, the higher priority the route
has.
Private This parameter determines if the LAN-Cell will include the route to this remote node
in its RIP broadcasts. If set to Yes, this route is kept private and not included in RIP
broadcast. If No, the route to this remote node will be propagated to other hosts
through RIP broadcasts.
Once you have completed filling in this menu, press [ENTER] at the message “Press ENTER to
Confirm…” to save your configuration, or press [ESC] to cancel.
Table 201 Menu 12. 1: Edit IP Static Route
FIELD DESCRIPTION