User`s guide

Chapter 2 Introducing the Web Configurator & Home Screen
LAN-Cell 2 User’s Guide
46
Figure 17 HOME > Show Statistics
The following table describes the labels in this screen.
2.3.6 Show Statistics: Line Chart
Click the icon in the Show Statistics screen. This screen shows you a line chart of each port’s
throughput statistics.
Table 5 HOME > Show Statistics
LABEL DESCRIPTION
Click the icon to display the chart of throughput statistics.
Port These are the LAN-Cell’s interfaces.
Status For the WAN interface(s) and the Dial Backup port, this displays the port speed and
duplex setting if you’re using Ethernet encapsulation or the remote node name for a
PPP connection and Down (line is down or not connected), Idle (line (ppp) idle),
Dial (starting to trigger a call) or Drop (dropping a call) if you’re using PPPoE
encapsulation.
For the LAN, DMZ and WLAN ports, this displays the port speed and duplex setting.
For the WLAN card, this displays the transmission rate when WLAN is enabled or
Down when WLAN is disabled.
TxPkts This is the number of transmitted packets on this port.
RxPkts This is the number of received packets on this port.
Tx B/s This displays the transmission speed in bytes per second on this port.
Rx B/s This displays the reception speed in bytes per second on this port.
Up Time This is the total amount of time the line has been up.
System Up Time This is the total time the LAN-Cell has been on.
Automatic
Refresh Interval
Select a number of seconds or None from the drop-down list box to update all
screen statistics automatically at the end of every time interval or to not update the
screen statistics.
Refresh Click this button to update the screen’s statistics immediately.