User`s guide

Chapter 28 DMZ Setup
LAN-Cell 2 User’s Guide
455
" DMZ, WLAN and LAN IP addresses must be on separate subnets. You must
also configure NAT for the DMZ port (see Chapter 33 on page 477) in menus
15.1 and 15.2.
28.3.2 IP Alias Setup
Use menu 5.2 to configure the first network. Move the cursor to the Edit IP Alias field, press
[SPACE BAR] to choose Yes and press [ENTER] to open Menu 5.2.1 - IP Alias Setup, as
shown next. Use this menu to configure the second and third networks.
Figure 276 Menu 5.2.1: IP Alias Setup
Refer to Table 190 on page 445 for instructions on configuring IP alias parameters.
Menu 5.2.1 - IP Alias Setup
IP Alias 1= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
IP Alias 2= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
Enter here to CONFIRM or ESC to CANCEL: