User`s guide

Chapter 27 Ethernet WAN Internet Access
LAN-Cell 2 User’s Guide
451
Figure 271 Ethernet WAN Setup (PPPoE)
The following table contains instructions about the new fields when you choose PPPoE in the
Encapsulation field in menu 4.
If you need a PPPoE service name to identify and reach the PPPoE server, please go to menu
11 and enter the PPPoE service name provided to you in the Service Name field.
27.5 Basic Setup Complete
Well done! You have successfully connected, installed and set up your LAN-Cell to operate
on your network as well as access the Internet.
" When the firewall is activated, the default policy allows all communications to
the Internet that originate from the LAN, and blocks all traffic to the LAN that
originates from the Internet, except for traffic to the LAN-Cell’s remote
management ports.
Menu 4 - Ethernet WAN Setup
ISP's Name= WAN
Encapsulation= PPPoE
Service Type= N/A
My Login=
My Password= ********
Retype to Confirm= ********
Idle Timeout= 100
IP Address Assignment= Dynamic
IP Address= N/A
IP Subnet Mask= N/A
Gateway IP Address= N/A
Network Address Translation= SUA Only
Press ENTER to Confirm or ESC to Cancel:
Table 193 New Fields in Menu 4 (PPPoE) screen
FIELD DESCRIPTION
Encapsulation Press [SPACE BAR] and then press [ENTER] to choose PPPoE. The
encapsulation method influences your choices in the IP Address field.
Idle Timeout This value specifies the time in seconds that elapses before the LAN-Cell
automatically disconnects from the PPPoE server.