User`s guide

Chapter 25 WAN, 3G and Dial Backup Setup
LAN-Cell 2 User’s Guide
437
Figure 262 3G Modem Setup in WAN Setup
The following table describes the fields in this screen.
25.4.2 Remote Node Profile (3G WAN)
Enter 2 in Menu 11 - WAN ISP Setup to open Menu 11.2 - Remote Node Profile (Cellular
3G WAN) (shown below) and configure the setup for your 3G connection.
Menu 2 - WAN Setup
WAN MAC Address:
Assigned By= Factory default
IP Address= N/A
Dial-Backup:
Active= No
Port Speed= 115200
AT Command String:
Init= at&fs0=0
Edit Advanced Setup= No
Cellular Modem Setup:
Init= Configure APN
APN = internet
PIN code=0000
Press ENTER to Confirm or ESC to Cancel:
Table 186 3G Modem Setup in WAN Setup
FIELD DESCRIPTION
Cellular Modem
Setup
Init Press [SPACEBAR] to toggle between Configure APN and Configure Directly.
When selecting Configure APN, enter the appropriate APN in the next field. When
selecting Configure Directly, enter the appropriate 3G modem initialization string.
APN Enter the APN (Access Point Name) provided by your service provider. Connections
with different APNs may provide different services (such as Internet access or MMS
(Multi-Media Messaging Service)) and charge method.
You can enter up to 31 ASCII printable characters. Spaces are allowed.
PIN Code A PIN (Personal Identification Number) code is a key to a 3G card. Without the PIN
code, you cannot use the 3G card.
Enter the 4-digit PIN code (0000 for example) provided by your ISP. If you enter the
PIN code incorrectly, the 3G card may be blocked by your ISP and you cannot use
the account to access the Internet.
If your ISP disabled PIN code authentication, enter an arbitrary number.
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm…” to
save your configuration, or press [ESC] at any time to cancel.