User`s guide

Chapter 25 WAN, 3G and Dial Backup Setup
LAN-Cell 2 User’s Guide
436
25.3.6 Remote Node Filter
Move the cursor to the field Edit Filter Sets in menu 11.3, and then press [SPACE BAR] to
set the value to Yes. Press [ENTER] to open Menu 11.3.4 - Remote Node Filter.
Use menu 11.3.4 to specify the filter set(s) to apply to the incoming and outgoing traffic
between this remote node and the LAN-Cell to prevent certain packets from triggering calls.
You can specify up to four filter sets separated by commas, for example, 1, 5, 9, 12, in each
filter field. Note that spaces are accepted in this field. Please refer to Chapter 35 on page 499
for more information on defining the filters.
Figure 261 Menu 11.3.4: Remote Node Filter
25.4 3G WAN
3G (Third Generation) is a digital, packet-switched wireless technology. Bandwidth usage is
optimized as multiple users share the same channel and bandwidth is only allocated to users
when they send data. It allows fast transfer of voice and non-voice data and provides
broadband Internet access to mobile devices. See Section 5.4 on page 114 for more
information.
To set up a 3G connection, you need to configure
1 Menu 2 - WAN Setup,
2 Menu 11.2 - Remote Node Profile (Cellular 3G WAN)
25.4.1 3G Modem Setup
From the main menu, enter 2 to open menu 2.
Menu 11.3.4 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Call Filter Sets:
protocol filters=
device filters=
Enter here to CONFIRM or ESC to CANCEL: