User`s guide

Chapter 25 WAN, 3G and Dial Backup Setup
LAN-Cell 2 User’s Guide
431
25.3.3 Remote Node Profile (Backup ISP)
Enter 3 in Menu 11 - WAN ISP Setup to open Menu 11.3 - Remote Node Profile (Backup
ISP) (shown below) and configure the setup for your Dial Backup port connection. Not all
fields are available on all models.
Figure 258 Menu 11.3: Remote Node Profile (Backup ISP)
Table 182 Advanced WAN Port Setup: Call Control Parameters
FIELD DESCRIPTION
Call Control
Dial Timeout (sec) Enter a number of seconds for the LAN-Cell to keep trying to set up an outgoing
call before timing out (stopping). The LAN-Cell times out and stops if it cannot set
up an outgoing call within the timeout value.
Retry Count Enter a number of times for the LAN-Cell to retry a busy or no-answer phone
number before blacklisting the number.
Retry Interval (sec) Enter a number of seconds for the LAN-Cell to wait before trying another call
after a call has failed. This applies before a phone number is blacklisted.
Drop Timeout (sec) Enter a number of seconds for the LAN-Cell to wait before dropping the DTR
signal if it does not receive a positive disconnect confirmation.
Call Back Delay
(sec)
Enter a number of seconds for the LAN-Cell to wait between dropping a callback
request call and dialing the co-responding callback call.
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm…” to
save your configuration, or press [ESC] at any time to cancel.
Menu 11.3 - Remote Node Profile (Backup ISP)
Rem Node Name=
Active= No
Edit IP= No
Outgoing: Edit Script Options= No
My Login= ChangeMe
My Password= ******** Telco Option:
Retype to Confirm= ******** Allocated Budget(min)= 0
Authen= CHAP/PAP Period(hr)= 0
Pri Phone #= 0 Schedules=
Sec Phone #= Always On= No
Session Options:
Edit Filter Sets= No
Idle Timeout(sec)= 100
Press ENTER to Confirm or ESC to Cancel: