User`s guide

Chapter 23 Introducing the SMT
LAN-Cell 2 User’s Guide
416
" SMT menu numbers are not sequential. SMT menu numbering has been
maintained for backward compatibility with previous LAN-Cell models and
customer scripting support.
The following table describes the fields in this menu.
Table 173 Main Menu Summary
NO
.
MENU TITLE FUNCTION
1 General Setup Use this menu to set up device mode, dynamic DNS and
administrative information.
2 WAN Setup Use this menu to clone a MAC address from a computer on your LAN
and configure the backup WAN dial-up connection. You can also use
this menu to configure 3G modem setting on the LAN-Cell.
3 LAN Setup Use this menu to apply LAN filters, configure LAN DHCP and TCP/IP
settings.
4 Ethernet WAN Setup Configure your Ethernet WAN access setup (Internet address,
gateway, login, etc.) with this menu.
5 DMZ Setup Use this menu to apply DMZ filters, and configure DHCP and TCP/IP
settings for the DMZ port.
6 Route Setup Use this menu to configure your WAN route assessment, traffic
redirect properties and failover parameters.
7 WLAN Setup Use this menu to configure WLAN DHCP and TCP/IP settings for the
wireless LAN interface.
11 WAN ISP Setup Use this menu to configure detailed remote node settings (your ISP is
also a remote node) as well as apply WAN filters.
12 Static Routing Setup Configure IP static routes in this menu.
15 NAT Setup Use this menu to configure Network Address Translation.
21 Filter and Firewall
Setup
Configure filters and activate/deactivate the firewall.
22 SNMP Configuration Use this menu to configure SNMP-related parameters.
23 System Password Change your password in this menu (recommended).
24 System Maintenance From displaying system status to uploading firmware, this menu
provides comprehensive system maintenance.
25 IP Routing Policy Setup Configure and display policies for use in IP policy routing.
26 Schedule Setup Use this menu to schedule outgoing calls.
33 Cellular Card
Command Mode
When the 3G cellular modem card is not in an active data session, this
menu provides access to the modem’s command line interface (if
supported by the 3G card). Refer to the 3G card manufacturer’s
documentation for applicable commands in this mode. Type [EXIT]
to return to the SMT.
99 Exit Use this menu to exit (necessary for remote configuration).