User`s guide

Chapter 22 Maintenance Screens
LAN-Cell 2 User’s Guide
407
If you uploaded the default configuration file you may need to change the IP address of your
computer to be in the same subnet as that of the default device IP address (192.168.1.1).
If the upload was not successful, the following screen will appear. Click Return to go back to
the Configuration screen.
Figure 243 Configuration Upload Error
Back to Factory Defaults
Click the Reset button to clear all user-entered configuration information and return the LAN-
Cell to its factory defaults as shown on the screen. The following warning screen appears.
Figure 244 Reset Warning Message
You can also press the hardware RESET button to reset the factory defaults of your LAN-
Cell. Refer to Section 2.4 on page 51 for more information on the RESET button.
22.7 Restart Screen
System restart allows you to reboot the LAN-Cell without turning the power off.
Click MAINTENANCE > Restart. Click Restart to have the LAN-Cell reboot. Restart is
different than Reset. Reset returns the device to its default configuration.