User`s guide

Chapter 15 Remote Management Screens
LAN-Cell 2 User’s Guide
333
" It is recommended that you disable Telnet and FTP when you configure SSH
for secure connections.
Figure 206 ADVANCED > REMOTE MGMT > FTP
The following table describes the labels in this screen.
15.10 SNMP Screen
Simple Network Management Protocol is a protocol used for exchanging management
information between network devices. SNMP is a member of the TCP/IP protocol suite. Your
LAN-Cell supports SNMP agent functionality, which allows a manager station to manage and
monitor the LAN-Cell through the network. The LAN-Cell supports SNMP version one
(SNMPv1). The next figure illustrates an SNMP management operation.
" SNMP is only available if TCP/IP is configured.
Table 123 ADVANCED > REMOTE MGMT > FTP
LABEL DESCRIPTION
Server Port You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Server Access Select the interface(s) through which a computer may access the LAN-Cell using
this service.
Secure Client IP
Address
A secure client is a “trusted” computer that is allowed to communicate with the LAN-
Cell using this service.
Select All to allow any computer to access the LAN-Cell using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the LAN-Cell using this service.
Apply Click Apply to save your customized settings.
Reset Click Reset to begin configuring this screen afresh.