User`s guide

Chapter 15 Remote Management Screens
LAN-Cell 2 User’s Guide
332
Click ADVANCED > REMOTE MGMT > TELNET to open the following screen. Use this
screen to specify which interfaces allow Telnet access and from which IP address the access
can come.
" It is recommended that you disable Telnet and FTP when you configure SSH
for secure connections.
Figure 205 ADVANCED > REMOTE MGMT > Telnet
The following table describes the labels in this screen.
15.9 FTP Screen
You can use FTP (File Transfer Protocol) to upload and download the LAN-Cell’s firmware
and configuration files, please see the User’s Guide chapter on firmware and configuration file
maintenance for details. To use this feature, your computer must have an FTP client.
To change your LAN-Cell’s FTP settings, click ADVANCED > REMOTE MGMT > FTP.
The screen appears as shown. Use this screen to specify which interfaces allow FTP access
and from which IP address the access can come.
Table 122 ADVANCED > REMOTE MGMT > Telnet
LABEL DESCRIPTION
Server Port You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Server Access Select the interface(s) through which a computer may access the LAN-Cell using
this service.
Secure Client IP
Address
A secure client is a “trusted” computer that is allowed to communicate with the LAN-
Cell using this service.
Select All to allow any computer to access the LAN-Cell using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the LAN-Cell using this service.
Apply Click Apply to save your customized settings and exit this screen.
Reset Click Reset to begin configuring this screen afresh.