User`s guide

Chapter 15 Remote Management Screens
LAN-Cell 2 User’s Guide
331
15.7 Configuring the SSH Screen
Click ADVANCED > REMOTE MGMT > SSH to change your LAN-Cell’s Secure Shell
settings.
" It is recommended that you disable Telnet and FTP when you configure SSH
for secure connections.
Figure 204 ADVANCED > REMOTE MGMT > SSH
The following table describes the labels in this screen.
15.8 Telnet Screen
You can use Telnet to access the LAN-Cell’s SMT or command line interface. Specify which
interfaces allow Telnet access and from which IP address the access can come.
Table 121 ADVANCED > REMOTE MGMT > SSH
LABEL DESCRIPTION
Server Host Key Select the certificate whose corresponding private key is to be used to identify the
LAN-Cell for SSH connections. You must have certificates already configured in the
My Certificates screen (Click My Certificates and see Chapter 11 on page 255 for
details).
Server Port You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Server Access Select the interface(s) through which a computer may access the LAN-Cell using
this service.
Secure Client IP
Address
A secure client is a “trusted” computer that is allowed to communicate with the
LAN-Cell using this service.
Select All to allow any computer to access the LAN-Cell using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the LAN-Cell using this service.
Apply Click Apply to save your customized settings and exit this screen.
Reset Click Reset to begin configuring this screen afresh.