User`s guide

Chapter 10 IPSec VPN Config Screens
LAN-Cell 2 User’s Guide
230
Address Type Use the drop-down list box to choose Single Address, Range Address, or
Subnet Address. Select Single Address for a single IP address. Select Range
Address for a specific range of IP addresses. Select Subnet Address to specify
IP addresses on a network by their subnet mask.
Starting IP
Address
When the Address Type field is configured to Single Address, enter a (static) IP
address on the LAN behind your LAN-Cell. When the Address Type field is
configured to Range Address, enter the beginning (static) IP address, in a range
of computers on the LAN behind your LAN-Cell. When the Address Type field is
configured to Subnet Address, this is a (static) IP address on the LAN behind
your LAN-Cell.
Ending IP
Address/Subnet
Mask
When the Address Type field is configured to Single Address, this field is N/A.
When the Address Type field is configured to Range Address, enter the end
(static) IP address, in a range of computers on the LAN behind your LAN-Cell.
When the Address Type field is configured to Subnet Address, this is a subnet
mask on the LAN behind your LAN-Cell.
Remote Network Remote IP addresses must be static and correspond to the remote IPSec router's
configured local IP addresses.
Two active SAs cannot have the local and remote IP address(es) both the same.
Two active SAs can have the same local or remote IP address, but not both. You
can configure multiple SAs between the same local and remote IP addresses, as
long as only one is active at any time.
Address Type Use the drop-down list box to choose Single Address, Range Address, or
Subnet Address. Select Single Address with a single IP address. Select Range
Address for a specific range of IP addresses. Select Subnet Address to specify
IP addresses on a network by their subnet mask.
Starting IP
Address
When the Address Type field is configured to Single Address, enter a (static) IP
address on the network behind the remote IPSec router. When the Addr Type field
is configured to Range Address, enter the beginning (static) IP address, in a
range of computers on the network behind the remote IPSec router. When the
Address Type field is configured to Subnet Address, enter a (static) IP address
on the network behind the remote IPSec router.
Ending IP
Address/Subnet
Mask
When the Address Type
field is configured to Single Address, this field is N/A.
When the Address Type field is configured to Range Address, enter the end
(static) IP address, in a range of computers on the network behind the remote
IPSec router. When the Address Type field is configured to Subnet Address,
enter a subnet mask on the network behind the remote IPSec router.
Gateway Policy Information
My LAN-Cell Enter the WAN IP address or the domain name of your LAN-Cell or leave the field
set to 0.0.0.0.
The LAN-Cell uses its current WAN IP address (static or dynamic) in setting up the
VPN tunnel if you leave this field as 0.0.0.0. If the WAN connection goes down, the
LAN-Cell uses the dial backup IP address for the VPN tunnel when using dial
backup or the LAN IP address when using traffic redirect.
The VPN tunnel has to be rebuilt if this IP address changes.
Primary Remote
Gateway
Type the WAN IP address or the domain name (up to 31 characters) of the IPSec
router with which you're making the VPN connection.
Manual Proposal
SPI Type a unique SPI (Security Parameter Index) from one to four characters long.
Valid Characters are "0, 1, 2, 3, 4, 5, 6, 7, 8, and 9".
Encapsulation
Mode
Select Tunnel mode or Transport mode from the drop-down list box.
Table 82 SECURITY > VPN > VPN Rules (Manual) > Edit (continued)
LABEL DESCRIPTION