User`s guide

Chapter 10 IPSec VPN Config Screens
LAN-Cell 2 User’s Guide
224
Figure 130 SECURITY > VPN > VPN Rules (IKE) > Edit Network Policy > Port Forwarding
The following table describes the labels in this screen.
Table 79 SECURITY > VPN > VPN Rules (IKE) > Edit Network Policy > Port Forwarding
LABEL DESCRIPTION
Default Server In addition to the servers for specified services, NAT supports a default server.
A default server receives packets from ports that are not specified in this
screen. If you do not assign a default server IP address, all packets received for
ports not specified in this screen are discarded.
# This is the number of an individual port forwarding server entry.
Active Select this check box to enable the port forwarding server entry. Clear this
check box to disallow forwarding of these ports to an inside server without
having to delete the entry.
Name Enter a name to identify this port-forwarding rule.
Start Port Type a port number in this field.
To forward only one port, type the port number again in the End Port field. To
forward a series of ports, type the start port number here and the end port
number in the End Port field.
End Port Type a port number in this field.
To forward only one port, type the port number in the Start Port field above and
then type it again in this field. To forward a series of ports, type the last port
number in a series that begins with the port number in the Start Port field
above.
Server IP Address Type your server IP address in this field.
Apply Click Apply to save your changes back to the LAN-Cell.
Reset Click Reset to begin configuring this screen afresh.