User`s guide

Chapter 9 Firewall Screens
LAN-Cell 2 User’s Guide
187
" The ordering of your rules is very important as rules are applied in the order
that they are listed.
Figure 103 SECURITY > FIREWALL > Rule Summary
The following table describes the labels in this screen.
Table 70 SECURITY > FIREWALL > Rule Summary
LABEL DESCRIPTION
Packet Direction Use the drop-down list boxes and click Refresh to select a direction of travel of
packets for which you want to display firewall rules.
To edit firewall rules for packets destined for one of the LAN-Cell’s
internal interfaces (such as a Remote Management port -- see
page 319), select the same interface name in the Source and
Destination drop-down listboxes (e.g. CELL to CELL) or select ANY as
the Destination to see all rules that apply from the indicated source .
The VPN connection directions apply to the traffic going to or from the LAN-Cell’s
VPN tunnels. They do not apply to other VPN traffic for which the LAN-Cell is not
one of the gateways (VPN pass-through traffic).
+/- In the heading row, click + to expand or - to collapse the Source Address,
Destination Address and Service Type drop down lists for all of the displayed rules.
Default Policy This field displays the default action and log policy you selected in the Default Rule
screen for the packet direction shown in the field above.
The following read-only fields summarize the rules you have created that apply to traffic traveling in the
selected packet direction. The firewall rules that you configure (summarized below) take priority over
the general firewall action settings above.