User`s guide

Chapter 8 Wi-Fi Screens
LAN-Cell 2 User’s Guide
165
The types of encryption you can choose depend on the type of user authentication. (See
Section on page 164 for information about this.)
For example, if the wireless network has a RADIUS server, you can choose WPA or WPA2.
If users do not log in to the wireless network, you can choose no encryption, Static WEP,
WPA-PSK, or WPA2-PSK.
Usually, you should set up the strongest encryption that every wireless client in the wireless
network supports. For example, suppose the AP does not have a local user database, and you
do not have a RADIUS server. Therefore, there is no user authentication. Suppose the wireless
network has two wireless clients. Device A only supports WEP, and device B supports WEP
and WPA. Therefore, you should set up Static WEP in the wireless network.
Note: It is recommended that wireless clients use WPA-PSK, WPA, or stronger
encryption. IEEE 802.1x and WEP encryption are better than none at all, but it
is still possible for unauthorized devices to figure out the original information
pretty quickly.
It is not possible to use WPA-PSK, WPA or stronger encryption with a local
user database. In this case, it is better to set up stronger encryption with no
authentication than to set up weaker encryption with the local user database.
Table 55 Types of Encryption for Each Type of Authentication
No Authentication RADIUS Server
Weakest No Security
Static WEP
802.1x +Static WEP
WPA-PSK WPA
Strongest WPA2-PSK or WPA2-PSK-Mix WPA2 or WPA2-Mix