User`s guide

Chapter 7 Wireless LAN (WLAN) Screens
LAN-Cell 2 User’s Guide
139
" See Appendix E on page 617 for more detailed information on WLANs.
7.2 WLAN Screen
The built-in Wi-Fi access point is used as part of the LAN by default. You can use the Port
Roles screen (see Figure 77 on page 145) to set a port to be part of the WLAN. Then connect
an external access point (AP) to it to extend the LAN-Cell’s wireless LAN coverage.
Click NETWORK > WLAN to open the WLAN screen to configure the IP address for LAN-
Cell’s WLAN interface, other TCP/IP and DHCP settings.
Figure 73 NETWORK > WLAN
The following table describes the labels in this screen.
Table 39 NETWORK > WLAN
LABEL DESCRIPTION
WLAN TCP/IP
IP Address Type the IP address of your LAN-Cell’s WLAN interface in dotted decimal notation.
Alternatively, click the right mouse button to copy and/or paste the IP address.
Note: Make sure the IP addresses of the LAN, WAN, WLAN and
DMZ are on separate subnets.