Service Manual

13
Mortise Service Manual
F.1 External Panel Installation
1. Ensure Ribbon Cable is secure in Exterior Trim first. Note that cable cannot be folded.
2. Then install Exterior Backplate and Gasket onto the Exterior Trim.
F.2 Insert Spindle F.3 Insert Ribbon Cable
1.
Insert the spindle (5) and spindle spring (6) into
the spring cage.
Ensure the lever rotates smoothly and drives the spindle
properly.
Having a hard time installing the spindle? Make sure the
handle is 90 perpendicular to the trim in the desired
orientation. Shifting the handle slightly may help
particularly troublesome spindles.
NOTE: Pay close attention to the spring. The small spring
is not attached to anything and can be easily misplaced.
1.
Insert the
ribbon cable into the oval opening on
the side of the door.
2. Pull the ribbon cable through the other side of the
door.
If necessary, use pliers to route the cable. Make sure the
cable is not bent or pinched.
F.4 Insert the Exterior Panel Assembly into the door F.5 Install Interior Backplate
(Ensure the
handle moves freely
)
1.
Insert the ribbon cable into the Interior Gasket (4)
and Interior Backplate (17).
2. Fasten the two set screws (16).