Service Manual

12
Mortise Service Manual
D.3 Proper Spring Cage Orientation Set Up (For Right Hand or Left Hand Reverse)
The factory default setting will work with LHR and RH.
The arrow should point in the direction you want the handle to
engage with the latch.
For Exterior Panel Spring Cage – Arrow should point counterclockwise.
For Interior Panel Spring Cage – Arrow should point clockwise.
Hardware Installation
E. Mortise Chassis Installation
1.
Route the cables through the door hole. Use pliers if necessary.
2. Slide Latch Monitoring Cable (19) and Motor Cable (20) through the door hole as shown.
3. Then, slide Mortise Lock chassis (20) into the door and screws (22) as shown (Do not fasten screws at this
point). It may be easiest with a second person to hold the chassis.
.
F. External Panel Installation
Insert Hex Bolts (9) onto the
Exterior Trim
(2)
.