Service Manual

11
Mortise Service Manual
C.2 Remove Free Wheeling Lever Set Screw C.3 Proper Spring Cage Orientation Set Up (For Left
Hand or Right-Hand Reverse)
See below. Note: arrow “B” must point down.
Only remove the screw from the reader/ external side of
the Mortise assembly.
1.
For Exterior Panel Spring Cag
e
-
Place the
spring
cage on the exterior side of the trim. Arrow should
point clockwise or in the direction you want the
handle to engage the latch.
2. Then, screw in the two set screws.
For Interior Panel Spring Cage – Arrow should point
counterclockwise.
D. Right Hand and Left-Hand Reverse Setup
D.1 Default factory assembly is set for both RH and
LHR
D.2 Remove Free Wheeling Lever Set Screw
Do not
remove
the latchbolt
.
1. Remove the front panel set screw (24) and the
front panel (23).
See below. Note: Arrow B must point down.
Only remove the screw from the reader/ external side of
the Mortise assembly.
Set Screw
Set Screw