Service Manual

10
Mortise Service Manual
B. Door Preparation
Measure the desired height from the floor to the door handle
.
Use the Mortise Lock Installation Template for prepping the Mortise door holes.
Using the provided template, drill out the proper holes in the door.
o Use a
3
4
inch hole saw to drill the hole for routing the cables through. If you do not have a hole saw,
use a
1
2
inch drill bit and drill two holes.
Lock Handing
Note: The lock is right handed by default. To rehand the lock, you will need to change the lock bolt
orientation.
C. Left Hand and Right Hand Reverse Set Up (See D for RH and LHR Set Up)
C.1 Latchbolt Orientation Set up
1.
Remove the front panel set screw (24)
and the front panel (23).
2. Then, unscrew the latch set screw.
3. Pull out the latchbolt, turn it 180, and
replace it in the chassis.
4. Then, screw back in the set screw.