User manual

Pag. 6
When the antenna sensor has been attached, covering the whole of the bumper from left to right, the
excess length is cut off. Place a piece of the included sticking material at either ends of the antenna
sensor to ensure a secure fixing onto the bumper. Its recommended (but not essential) to cover the
antenna with a black anti-rust protection paint that is applied to the underneath of a car chassis or
similar to protect from the elements (do not use silicon paste).
* NOTE:
1) It is advisble to start and finish the application of the antenna sensor tape et about 15 cm
from the both end of the bumper (Fig. 4).
2) The sensor antenna can not be applied on metal bumpers.
Fig. 4
Sticking material
15cm
Antenna sensor