User manual
SAS to SAS/SATA II RAID Subsystem
User Manual
73
5.3.5 Check Volume Set
Use this function to perform Volume Set consistency check, which verifies the
correctness of redundant data (data blocks and parity blocks) in a Volume Set. This
basically means computing the parity from the data blocks and comparing the results
to the contents of the parity blocks, or computing the data from the parity blocks and
comparing the results to the contents of the data blocks.
NOTE: The Volume Set state must be Normal in order to perform
Check Volume Set. Only RAID levels with parity (redundant data)
such as RAID Levels 3, 5, 6, 30, 50 and 60, support this function.
To perform Check Volume Set function:
1. Click on the Check Volume Set link.
2. Tick from the list the Volume Set you want to check. Select the Check Volume
Set options.
Check Volume Set Options:
Scrub Bad Block If Bad Block Found, Assume Parity Data is Good
Re-compute Parity if Parity Error, Assume Data is Good
NOTE: When the 2 options are not selected, it will only check for
errors. It is recommended to perform Check Volume Set with the
2 options unselected at first. If the result shows error, the two
options can be selected and redo Check Volume Set to correct the
errors.