User manual

SAS to SAS/SATA II RAID Subsystem
User Manual
31
3.3 Disk Drive Installation
This section describes the physical locations of the hard drives supported by the
subsystem and give instructions on installing a hard drive. The subsystem supports
hot-swapping allowing you to install or replace a hard drive while the subsystem is
running.
3.3.1 Installing a SAS Disk Drive in a Disk Tray
NOTE: These steps are the same when installing SATA disk drive in
Single Controller Mode.
1. Unlock the Disk Trays using a flat-head screw driver by rotating the Lock Groove.
2. Press the Tray Open button and the Disk Tray handle will flip open.
3. Pull out an empty disk tray.
Tray
Open
B
utto
n