User manual

SAS to SAS/SATA II JBOD Subsystem
28
User Manual
3.2.1.1 Replacing Controller Module with Plate Cover
When replacing a failed JBOD Controller Module with Plate Cover, please follow these
steps:
1. Loosen thumbscrews of the failed JBOD Controller Module drawer.
2. Use the Controller Module handle to remove the failed JBOD Controller Module
drawer from the subsystem.
3. Insert the JBOD Controller Plate Cover.
JBOD Controller Module Plate Cover
4. Tighten the thumbscrews of the Controller Plate Cover.
When replacing a failed component online, it is not recommended to
remove the failed component for a long period of time; proper air
flow within the enclosure might fail causing high controller/disk
drive temperature.