User manual

SAS to SAS/SATA II JBOD Subsystem
User Manual
21
2.2.2 Installing a SATA Disk Drive (Dual JBOD Controller Mode) in a
Disk Tray
1. Remove an empty disk tray from the subsystem.
2. Prepare the dongle board and two screws.
3. Place the dongle board in the disk tray. Turn the tray upside down. Align the
two screw hole of the dongle board in the two Hole D of the disk tray. Tighten
two screws to secure the dongle board into the disk tray.