User manual

SAS to SAS/SATA II JBOD Subsystem

User Manual

2.2 Disk Drive Installation

This section describes the physical locations of the hard drives supported by the

subsystem and give instructions on installing a hard drive. The subsystem

supports hot-swapping allowing you to install or replace a hard drive while the

subsystem is running.

2.2.1 Installing a SAS Disk Drive in a Disk Tray

NOTE: These steps are the same when installing SATA disk

drive in Single Controller Mode.

1. Unlock the Disk Trays using a flat-head screw driver by rotating the Lock

Groove.

2. Press the Tray Open button and the Disk Tray handle will flip open.

3. Pull out an empty disk tray.

Tray

Open

utto