User's Manual

M-WN910N Wireless N CardBus Adapter

Chapter 4 WPS configuration

WPS function allows you to add a new wireless device to an existing network quickly.

If the wireless card supports Wi-Fi Protected Setup (WPS), you can establish a wireless

connection between wireless card and router using either Push Button Configuration (PBC)

method or PIN method.

First, the WPS software should be installed. Insert the Resource CD into your CD-ROM drive,

Click the Start button and choose Run. In the field that appears, enter F:\WPS\WPS.exe

(Presume "F" is the letter of your CD-ROM drive) and click OK, then Figure 4-1

Figure 5-1 will

appear.

Figure 4-1

Then, please follow the clue of the Operation System to complete the WPS installation. After

that, WPS function can be enabled. Here we will introduce two ways to configure the WPS (For

the configuration of WPS, here takes the Wireless Router of our company for example).

4.1 PBC (Push Button Configuration) method

1. Firstly, press the WPS button of the Router. There are two ways:

1) Press the WPS button directly on the front panel of the Router shown in

XFigure

4-2Figure 5-2X.