User's Manual

RY/TP7231RY/TP723F " 522Odru"Yktgnguu"P"Tqwvgt"
- 69 -
Click the Fkucdng"Cnn button to disable all the entries.
Click the Fgngvg"Cnn button to delete all the entries.
Click the Rtgxkqwu button to view the information in the previous screen, click the Pgzv button to
view the information in the next screen.
603404"U{uvgo"Tqwvkpi"Vcdng"
Choose menu ›Cfxcpegf" Tqwvkpi" →" U{uvgo" Tqwvkpi" Vcdng”, and you can views all of the
valid route entries in use. The Destination IP address, Subnet Mask, Gateway, and Interface will
be displayed for each entry.
 Fguvkpcvkqp" Pgvyqtm" /" The Destination Network is the address of the network or host to
which the static route is assigned.
 Uwdpgv"Ocum"/"The Subnet Mask determines which portion of an IP address is the network
portion, and which portion is the host portion.
 Icvgyc{"/"This is the IP address of the gateway device that allows for contact between the
Router and the network or host.
 Kpvgthceg" /" This interface tells you whether the Destination IP Address is on the NCP" ("
YNCP (internal wired and wireless networks), the YCP*Kpvgtpgv+.
Click the Tghtguj button to refresh the data displayed.
6035"" Dcpfykfvj"Eqpvtqn"
Figure 4-64
There are two submenus under the Bandwidth Control menu as shown in Figure 4-64. Click any
of them, and you will be able to configure the corresponding function. The detailed explanations
for each submenu are provided below.
603503"Eqpvtqn"Ugvvkpiu"
Choose menu “Dcpfykfvj" Eqpvtqn" → " Eqpvtqn" Ugvvkpiu”, you can configure the Egress
Bandwidth and Ingress Bandwidth in the next screen. Their values you configure should be less