User's Manual

RY/TP7231RY/TP723F " 522Odru"Yktgnguu"P"Tqwvgt"
- 47 -
 Vtkiigt" Rtqvqeqn" / The protocol used for Trigger Ports, either VER, WFR, or Cnn" (all
protocols supported by the Router).
 Kpeqokpi"Rqtvu"/ The port or port range used by the remote system when it responds to the
outgoing request. A response using one of these ports will be forwarded to the PC that
triggered this rule. You can input at most 5 groups of ports (or port sections). Every group of
ports must be set apart with ",". For example, 2000-2038, 2050-2051, 2085, 3010-3030.
 Kpeqokpi"Rtqvqeqn"/ The protocol used for Incoming Ports Range, either VER or WFR, or
CNN (all protocols supported by the Router).
 Uvcvwu"/ The status of this entry, either Gpcdngf or Fkucdngf.
Vq"cff"c"pgy"twng."hqnnqy"vjg"uvgru"dgnqy0" "
1. Click the"Cff"Pgy”"button, the next screen will pop-up as shown in Figure 4-35.
2.
Select a common application from the Eqooqp" Crrnkecvkqpu drop-down list, then the
Vtkiigt"Rqtv"field and the Kpeqokpi"Rqtvu field will be automatically filled. If the Eqooqp"
Crrnkecvkqpu" do not have the application you need, enter the Vtkiigt" Rqtv" and the
Kpeqokpi"Rqtvu manually.
3. Select the protocol used for Trigger Port from the Vtkiigt"Rtqvqeqn drop-down list, either
VER, WFR, or Cnn.
4. Select the protocol used for Incoming Ports from the Kpeqokpi" Rtqvqeqn drop-down list,
either VER or WFR, or Cnn0
5. Select Gpcdng"in Uvcvwu field.
6. Click the Ucxg button to save the new rule.
Figure 4-35 Add or Modify a Port Triggering Entry
Vq"oqfkh{"qt"fgngvg"cp"gzkuvkpi"gpvt{<"
1. Click the Oqfkh{"in the entry you want to modify. If you want to delete the entry, click the"
Fgngvg.
2. Modify the information.