User's Manual

PW-RN401/PW-RN401D
150M Wireless N Router
- 57 -
 UDP-FLOOD Packets Threshold (5~3600) - The default value is 500. Enter a value between
5 ~ 3600. When the current UPD-FLOOD Packets number is beyond the set value, the Router
will startup the blocking function immediately.
 Enable TCP-SYN-FLOOD Attack Filtering - Enable or Disable the TCP-SYN-FLOOD Attack
Filtering.
 TCP-SYN-FLOOD Packets Threshold (5~3600) - The default value is 50. Enter a value
between 5 ~ 3600. When the current TCP-SYN-FLOOD Packets numbers is beyond the set
value, the Router will startup the blocking function immediately.
 Ignore Ping Packet From WAN Port - Enable or Disable Ignore Ping Packet From WAN Port.
The default setting is disabled. If enabled, the ping packet from the Internet cannot access the
Router.
 Forbid Ping Packet From LAN Port - Enable or Disable Forbid Ping Packet From LAN Port.
The default setting is disabled. If enabled, the ping packet from LAN cannot access the
Router. This function can be used to defend against some viruses.
Click the Save button to save the settings.
Click the Blocked DoS Host List button to display the DoS host table by blocking.
4.10 Advanced Routing
Choose menu “Advanced Routing”, and you can configure the static route in the next screen,
shown in Figure 4-45. A static route is a pre-determined path that network information must travel
to reach a specific host or network.
Figure 4-45 Static Routing
To add static routing entries, follow the steps below.
1. Click Add New… shown in Figure 4-45, you will see the following screen Figure 4-46.