User's Guide
Table Of Contents
- Package Contents
- Chapter 1. Introduction
- Chapter 2. Connecting the Router
- Chapter 3. Quick Installation Guide
- Chapter 4. Configuration for AP Mode
- Chapter 5. Configuration for Router Mode
- Chapter 6. Configuration for Repeater Mode
- Chapter 7. Configuration for Bridge Mode
- Chapter 8. Configuration for Client Mode
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
- Appendix D: Glossary
PW-RN401M
150Mbps Wireless N Nano Router
- 55 -
5.3 Quick Setup
Please refer to Section 3.2: "Quick Installation Guide."
5.4 Working Mode
The Router supports five operation mode types: AP, Router, Repeater, Bridge and Client.
Please select one your want. Click Save to save your choice, which is shown as Figure 5-3.
Figure 5-3 Wireless Working Mode Settings
AP - The wireless access point mode.
Router - The wireless Router Mode. In this mode, the device enables multi-user to share
Internet via DSL/Cable Modem. The only wired port works as WAN.
Repeater - The wireless Repeater Mode. It could extend the range of wireless network.
Bridge - The wireless Bridge Mode. It could communicate with another wireless network.
Client - The Client Mode. The computer connected by Ethernet could get access to an AP by
Client mode.
Click OK in the following screen and then the Router will reboot and to work on Router Mode.
Figure 5-4