User's Guide
Table Of Contents
- Package Contents
- Chapter 1. Introduction
- Chapter 2. Connecting the Router
- Chapter 3. Quick Installation Guide
- Chapter 4. Configuration for AP Mode
- Chapter 5. Configuration for Router Mode
- Chapter 6. Configuration for Repeater Mode
- Chapter 7. Configuration for Bridge Mode
- Chapter 8. Configuration for Client Mode
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
- Appendix D: Glossary
PW-RN401M
150Mbps Wireless N Nano Router
- 36 -
2. Failure to follow these guidelines can result in significant performance degradation or inability
to wirelessly connect to the Router.
4.6.2 Wireless Security
Choose menu “Wireless
→
Wireless Security”, and then you can configure the security
settings of your wireless network.
There are three wireless security modes supported by the Router: WEP (Wired Equivalent
Privacy), WPA/WPA2 and WPA-PSK/WPA2-PSK.
Figure 4-9 Wireless Security
Disable Security - The wireless security function can be enabled or disabled. If disabled, the
wireless stations will be able to connect the Router without encryption. But it’s strongly
recommended to choose one of the following modes to enable security.
WEP - It is based on the IEEE 802.11 standard.
• Type - you can choose the type for the WEP security on the pull-down list. The default
setting is Automatic, which can select
Shared Key or Open System authentication type
automatically based on the wireless station's capability and request.