User's Guide

PW-RN401M
150Mbps Wireless N Nano Router
- 22 -
3.2.4 Bridge Mode
When you choose Bridge on Working Mode page in Figure 3-5 , take the following steps:
1. Click Next, and then Wireless Repeater page will appear as shown in Figure 3-17.
Figure 3-17 Quick Setup - Wireless Bridge
 SSID - Enter a string of up to 32 characters. The same name of SSID (Service Set
Identification) must be assigned to all wireless devices in your network. The default SSID is
set to be Wireless_XXXXXX (XXXXXX indicates the last unique six numbers of each
Router’s MAC address). But it is recommended strongly that you change your networks
name (SSID) to a different value. This value is case-sensitive. For example, TEST is NOT
the same as test.
 Region - Select your region from the pull-down list. This field specifies the region where the
wireless function of the Router can be used. It may be illegal to use the wireless function of
the Router in a region other than one of those specified in this field. If your country or region
is not listed, please contact your local government agency for assistance.
 Channel - This field determines which operating frequency will be used. It is not necessary
to change the wireless channel unless you notice interference problems with another nearby
access point. If you select auto, then AP will choose the best channel automatically.
 Mode - Select the desired mode. The default setting is 11bgn mixed.
11b only - Select if all of your wireless clients are 802.11b.