User's Guide
Table Of Contents
- Package Contents
- Chapter 1. Introduction
- Chapter 2. Connecting the Router
- Chapter 3. Quick Installation Guide
- Chapter 4. Configuration for AP Mode
- Chapter 5. Configuration for Router Mode
- Chapter 6. Configuration for Repeater Mode
- Chapter 7. Configuration for Bridge Mode
- Chapter 8. Configuration for Client Mode
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
- Appendix D: Glossary
PW-RN401M
150Mbps Wireless N Nano Router
- 10 -
Chapter 3. Quick Installation Guide
This chapter will show you how to configure the basic functions of your PW-RN401M 150Mbps
Wireless N Nano Router using Quick Setup Wizard within minutes.
3.1 TCP/IP Configuration
The default IP address of the PW-RN401M 150Mbps Wireless N Nano Router is 192.168.1.254.
And the default Subnet Mask is 255.255.255.0. These values can be changed as you desire. In
this guide, we use all the default values for description. You can configure the IP address
manually for your PC as the following steps:
1) Set up the TCP/IP Protocol for your PC. If you need instructions as to how to do this, please
refer to Appendix B: "Configuring the PC"
.
2) Configure the network parameters. The IP address is 192.168.1.x ("x" is any number from 1
to 253), Subnet Mask is 255.255.255.0, and Gateway is 192.168.1.254 (The Router's
default IP address).
Then connect to the Router through wireless connection following the steps below:
1) Click the icon
at the bottom of your desktop. Click refresh button, and then select the
default SSID of the Router. Click Connect.
2) Enter the Security key. Click OK.