User's Guide
Table Of Contents
- Package Contents
- Chapter 1. Introduction
- Chapter 2. Connecting the Router
- Chapter 3. Quick Installation Guide
- Chapter 4. Configuration for AP Mode
- Chapter 5. Configuration for Router Mode
- Chapter 6. Configuration for Repeater Mode
- Chapter 7. Configuration for Bridge Mode
- Chapter 8. Configuration for Client Mode
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
- Appendix D: Glossary
PW-RN401M
150Mbps Wireless N Nano Router
- 9 -
On this mode, the only wired port works as LAN. Computer could connect to the device by either
wired or wireless way. To avoid the conflict of DHCP service with front-end devices, the DHCP
server is default to be closed on this mode. If you want to log in the management page, please set
your computer’s IP address manually.
Figure 2-5 Hardware Installation of the PW-RN401M in Client Mode
1. Connect the PC to the LAN/WAN port of PW-RN401M router with an Ethernet cable.
2. Plug the power plug of PW-RN401M in electrical wall socket.
3. Power on the PC(s).
Note:
PW-RN401M can be powered by external power adapter or USB connection to computer.