User's Guide
Table Of Contents
- Package Contents
- Chapter 1. Introduction
- Chapter 2. Connecting the Router
- Chapter 3. Quick Installation Guide
- Chapter 4. Configuration for AP Mode
- Chapter 5. Configuration for Router Mode
- Chapter 6. Configuration for Repeater Mode
- Chapter 7. Configuration for Bridge Mode
- Chapter 8. Configuration for Client Mode
- Appendix A: FAQ
- Appendix B: Configuring the PC
- Appendix C: Specifications
- Appendix D: Glossary
PW-RN401M
150Mbps Wireless N Nano Router
- 7 -
Figure 2-2 Hardware Installation of the PW-RN401M in Router Mode
1. Connect the WAN port of PW-RN401M to the LAN Port on the DSL/Cable Modem.
2. Connect the WAN port on the DSL/Cable Modem to the wired Internet.
3. Plug the power plug of PW-RN401M in electrical wall socket.
4. Power on the DSL/Cable Modem, PC(s) and notebook(s).
2.3.3 Repeater Mode
PW-RN401M is used to extend the range of wireless signal of the existing AP or wireless router.
On this mode, the only wired port works as LAN. Computer could connect to the device by either
wired or wireless way. The SSID of PW-RN401M should be the same as that of the device you
repeat. To avoid the conflict of DHCP service with front-end devices, the DHCP server is default to
be closed on this mode. If you want to log in the management page, please set your computer’s IP
address manually.
Figure 2-3 Hardware Installation of the PW-RN401M in Repeater Mode