PW-MN527 300Mbps Wireless N USB Module User Guide Version 1.0 July 31, 2012 PROWARE TECHNOLOGIES CO., Ltd.
Copyright Notice: Copyright © 2012, PROWARE Technologies CO,. Ltd . All Rights Reserved. No part of this document may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise without the prior written permission of PROWARE Technologies CO,. Ltd is a registered trademark of PROWARE Technologies CO,. Ltd.
Revision History Release Date Revision 1.0 2012-7-31 First release.
FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
As long as 2 conditions above are met, further transmitter test will not be required. However, the OEM integrator is still responsible for testing their end-product for any additional compliance requirements required with this module installed IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop configurations or co-location with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID can not be used on the final product.
CONTENTS Package Contents .................................................................................................... 7 Chapter 1 Introduction ........................................................................................... 8 1.1 Overview of the Product ............................................................................................ 8 1.2 Features.....................................................................................................................
PW-MN527 300Mbps Wireless N USB Module Package Contents The following items should be found in your package: PW-MN527 300Mbps Wireless N USB Module Note: Make sure that the package contains the above items. If any of the listed items are damaged or missing, please contact with your distributor. Conventions: The ‘Module’ mentioned in this user guide stands for PW-MN527 300Mbps Wireless N USB Module without any explanations.
PW-MN527 300Mbps Wireless N USB Module Chapter 1 Introduction Thank you for choosing the PW-MN527 300Mbps Wireless N USB Module! 1.1 Overview of the Product The module is an 802.11n client device. It is mainly designed to provide a high-speed and unrivaled wireless performance for wireless embedded system application. With a faster wireless connection, you can get a better Internet experience without the cost of running network cables. With the 802.
PW-MN527 300Mbps Wireless N USB Module Chapter 2 Installation Guide 2.1 Hardware Installation PW-MN527 has USB interface, and it is mainly designed to provide stability wireless function and performance for your system. For installation, you must be sure to connect this module to your device or system with a connecting wire first. Then, the promoted Found New Hardware Wizard will pop up if the Module is installed correctly. 2.
PW-MN527 300Mbps Wireless N USB Module 4. Select ‘Install from a list or specific location (Advanced)’ and then click ‘Next’ 5.
PW-MN527 300Mbps Wireless N USB Module 6. Select the file which we decompress at step 1 and then click ‘OK’ 7.
PW-MN527 300Mbps Wireless N USB Module 8. Finally click ‘Finish’ 9. If you want to check if the driver is installed successfully, please click ‘Properties’ of the card in the Device Manager. Click driver label to see the detail information.
PW-MN527 13 300Mbps Wireless N USB Module
PW-MN527 300Mbps Wireless N USB Module Chapter 3 Linux Installation Guide (For Consumer Electronics) 3.1 Hardware Installation For the Consumer Electronics products which use PW-MN527, it must provide a corresponding connector for the module. After connecting the module to the device, the hardware installation is finished. 3.2 Software Installation For the Consumer Electronics products, the Linux Driver of PW-MN527 is embedded in default. So the module is a plug and play device.
PW-MN527 300Mbps Wireless N USB Module Appendix A: Specifications Normal Interface USB 2.0 Interface Standards IEEE802.11n; IEEE802.11g; IEEE802.11b; Operating System Windows XP, 7 Throughput 300Mbps (Maximal) 11b: up to11Mbps (Dynamic) Radio Data Rate 11g: up to 54Mbps (Dynamic) 11n: up to 300Mbps (Dynamic) Modulation BPSK, QPSK, 16-QAM, 64-QAM, DBPSK, DQPSK, and CCK Media Access Protocol CSMA/CA with ACK Data Security WPA/WPA2; 64/128-bit WEP; TKIP/AES Frequency 2.4 ~ 2.
PW-MN527 300Mbps Wireless N USB Module Appendix B: Glossary 802.11b - The 802.11b standard specifies a wireless product networking at 11 Mbps using direct-sequence spread-spectrum (DSSS) technology and operating in the unlicensed radio spectrum at 2.4GHz, and WEP encryption for security. 802.11b networks are also referred to as Wi-Fi networks. 802.
PW-MN527 300Mbps Wireless N USB Module developed by the military for use in reliable, secure, mission-critical communications systems. It is designed to trade off bandwidth efficiency for reliability, integrity, and security. In other words, more bandwidth is consumed than in the case of narrowband transmission, but the trade off produces a signal that is, in effect, louder and thus easier to detect, provided that the receiver knows the parameters of the spread-spectrum signal being broadcast.
