Operating Instructions

PW-MN427_56I 150Mbps Wireless N USB Module User Guide
- 3 -
Chapter 2 Installation Guide
2.1 Hardware Installation
PW-MN427_56I has a 4-Pin onboard connector to transmit USB signal, and it is mainly designed
to provide stability wireless function and performance for your system.
For installation, you must be sure to connect this module to your device or system’s compatible
connector, sometimes you should use a connecting wire first. Then, the promoted Found New
Hardware Wizard will pop up if the Module is installed correctly.
2.2 Software Installation
2.2.1 Overview
The Module’s Setup Wizard will guide you through the installation of the Utility and drivers. Before
you install the software, please connect the USB Module with your computer by USB cable. After
that, you will be prompted “Found New Hardware Wizard”, click the Cancel button, and run the
Setup Wizard program on the CD-ROM.
 Note:
The Setup steps for Windows XP/ Vista/ 7 are very similar, so the following installation guide
takes Windows XP for example.
2.2.2 Installation Guide
1. Insert the Resource CD into your CD-ROM drive, then go to My Computer to double-click