User's Guide
Table Of Contents
PW-MN421 Wireless Lite-N USB Module
3
Chapter 2 Installation Guide
2.1 Hardware Installation
PW-MN427_56I has a 4-Pin onboard connector to transmit USB signal, and it is mainly
designed to provide stability wireless function and performance for your system.
For installation, you must be sure to connect this module to your device or system’s compatible
connector, sometimes you should use a connecting wire first. Then, the promoted Found New
Hardware Wizard will pop up if the Module is installed correctly.
2.2 Software Installation
Windows XP, Vista, 7 are supported. This user guide takes Windows XP for example.
1. Please run the Setup program of the module. Then you will see
Figure 2-1.