User Manual
Table Of Contents
- Package Contents
- Chapter 1 Introduction
- Chapter 2 Hardware Installation
- Chapter 3 Quick Installation Guide
- Chapter 4 Configure the Device
- Appendix A: Application Example
- Appendix B: Factory Defaults
- Appendix C: Troubleshooting
- Appendix D: Specifications
- Appendix E: Glossary
PW-AN401/PW-AN401D 150M Wireless N Access Point User Guide
15
1) Click Survey, then the window displaying a list of available SSIDs will appear in Figure
3-14.
2) Find the SSID of the Access Point / Router or WISP, and click Connect in the corresponding
row. You will then return to the page shown in Figure 3-15.
3)
Select the security mode and enter the password that is the same as on your router or
access point.
4) Click Next in Figure 3-15, then the page below will appear.
You can name the bridge AP
in Loc
al Wireless Name. With Use the same security
settings for the local wireless network as the root AP selected, the security settings
of the wireless network will be the same with the root AP.
Figure 3-16
)
Note:
If you do not select Use the same security settings for the local wireless network as the
root AP, the page will be shown as below, you can then separately configure the security
settings for the local wireless network.
When the Wireless Security Mode in this page and in Figure 3-15 are both chosen
Secure(WEP), the security settings of the local wireless network will/shall keep the same with
the root AP.