User's Manual

PW-3G401/PW-3G401D 3G Wireless N Router
1.4 Panel Layout
1.4.1 The Front Panel
Figure 1-1 Front Panel sketch
The Router’s LEDs and the WPS/Reset Button are located on the front panel (View from left to
right).
Name Status Indication
On Power is on.
PWR
Off Power is off.
On The Router is initializing.
Flashing The Router is working properly.
SYS
Off The Router has a system error.
Flashing The Wireless function is enabled.
WLAN
Off The Wireless function is disabled.
On A device is linked to the corresponding port but there is no activity.
Flashing An active device is linked to the corresponding port.
WAN,
LAN1-4
Off No device is linked to the corresponding port.
On The USB 3G dongle is connected.
Flashing Data is received or sent through the 3G dongle.
3G
Off No device is linked to the USB port.
Slow Flash
A wireless device is connecting to the network by WPS function.
This process will last for about 2 minutes.
On
A wireless device has been successfully added to the network by
WPS function. The LED will keep on for about 5 minutes.
WPS/Reset
Quick Flash
A wireless device has failed to be added to the network by WPS
function.
Table 1-1 The LEDs description

Note:
1. When a device has been successfully added to the network by WPS function, the WPS
LED will keep on for about 5 minutes and then turn off.
2. When pressing and holding the WPS/Reset Button for more than 5 seconds, you will reset
the router.
-4-