User's Guide

PW-3G401M 3G Wireless N Nano Router
¾ Wireless Network Name (also called SSID) - Identifies your wireless network name. Create
a name up to 32 characters and make sure all wireless points in the wireless network with the
same SSID. The default SSID is Wireless_3020_XXXXXX (XXXXXX indicates the last
unique six characters of each device’s MAC address). This value is case-sensitive. For
example, TEST is NOT the same as test.
¾ Region - Select your region from the pull-down list. This field specifies the region where the
wireless function of the device can be used. It may be illegal to use the wireless function of
the device in a region other than one of those specified in this field. If your country or region is
not listed, please contact your local government agency for assistance.
When you select your local region from the pull-down list, click the Save button, then the Note
Dialog appears. Click OK.
Note Dialog
)
Note:
Limited by local law regulations, version for North America does not have region selection
option.
¾ Channel - Determines the operating frequency to be used. It is not necessary to change
the wireless channel unless you notice interference problems with another nearby access
point.
¾ Mode - Select the desired wireless mode. The options are:
• 11b only - Only 802.11b wireless stations can connect to the device.
• 11g only - Only 802.11g wireless stations can connect to the device.
• 11n only - Only 802.11n wireless stations can connect to the device.
• 11bg mixed - Both 802.11b and 802.11g wireless stations can connect to the device.
• 11bgn mixed - All 802.11b, 802.11g and 802.11n wireless stations can connect to the
device.
¾ Channel Width - Determines the channel width to be used. It is unnecessary to change
the default value unless required.
¾ Max Tx Rate - Specifies the maximum transmit rate of the device through this field.
¾ Enable Wireless Radio - Select or deselect this check box to allow or deny wireless
stations to access the device.
-195-