User's Guide
Table Of Contents
- Package Contents
- Chapter 1. Introduction
- Chapter 2. Connecting the Router
- Chapter 3. Quick Installation Guide
- Chapter 4. Router Configuration – 3G Router Mode
- Chapter 5. Router Configuration – Wireless Router Mode
- Chapter 6. Router Configuration— Standard AP Mode
- Appendix A: FAQ
- Appendix B: Configuring the PCs
- Appendix C: Specifications
- Appendix D: Glossary
- Appendix E: Compatible 3G/4G USB Modem
PW-3G401M 3G Wireless N Nano Router
connect to the network wirelessly by means of PW-3G401M.
1. Connect one end of the provided USB cable to mini USB port of the Router and the other
end to the power adapter, and then plug the power adapter to a standard electrical wall
socket.
2. Connect the LAN/WAN port of the Router to the wired network port via an Ethernet cable.
3. Connect the notebook/PC to the Router wirelessly.
z Repeater Mode
In this mode, PW-3G401M is used to extend the range of wireless signal of the root AP.
PW-3G401M is required to set the same wireless network name (also called SSID) and wireless
security with the root AP, but the different IP addresses to avoid conflict.
1. Connect one end of the provided USB cable to mini USB port of the Router and the other
end to the power adapter, and then plug the power adapter to a standard electrical wall
socket.
2. Connect to the target remote AP or Router wirelessly.
3. Connect the notebook/PC to the Router via an Ethernet cable or wirelessly.
z Bridge with AP Mode
In this mode, PW-3G401M bridges the root AP and up to 4 APs (also in bridge mode) to connect
two or more wired LANs. Different to the repeater mode, PW-3G401M can set a different SSID
and wireless security.
-7-