User's Guide

PW-3G401M 3G Wireless N Nano Router
Chapter 2. Connecting the Router
2.1 System Requirements
¾ 3G/4G Mobile Broadband Internet Access Service (With a UMTS/HSPA/EVDO USB
dongle)
¾ PCs with a working Ethernet Adapter and an Ethernet cable with RJ45 connectors
¾ TCP/IP protocol on each PC
¾ Web browser, such as Microsoft Internet Explorer 5.0 , Netscape Navigator 6.0 or above
2.2 Installation Environment Requirements
¾ Place the Router in a well ventilated place far from any heater or heating vent
¾ Avoid direct irradiation of any strong light (such as sunlight)
¾ Keep at least 2 inches (5 cm) of clear space around the Router
¾ Operating Temperature: 0 ~40 (32 ~104 )℃℃℉ ℉
¾ Operating Humidity: 10%~90%RH, Non-condensing
2.3 Connecting the Router
There are totally six operation modes supported by this Router: 3G Router, Wireless Router,
Standard AP (including Access Point, Repeater, Bridge with AP, and Client). Please connect
your devices according to the mode you are going to apply.
Note: Before hardware connection, please write down the SSID and Password on the label of
your PW-3G401M for later use.
¾ 3G Router Mode
By default, PW-3G401M is used as 3G Router. Plug your 3G modem into the USB port, configure
the necessary parameters on the web-based management page of the Router, and then you can
enjoy the Internet. In this mode, the LAN/WAN port is used as LAN port for wired connection with
your computer. Other devices can share the Internet wirelessly.
-5-