User manual

3 4
Tailplate Sketch
Tailplate
Mount screw
Lens
Socket Auto Iris Lens
Lens mount ring
1
2
4
5
Structure and Components
Details:
① OSD Menu
② Indicator Led
③ Socket Auto Iris Lens
④ Video out
⑤ Power Supply Socket
(1) Use the designated power supply supplied by the vendor.
(2) Fasten the Lens you have chosen onto the "Lens Mount ring". In
case of Auto Iris Lens, connect the Lens cable to the "Auto Iris
Socket".
(3) Connect Video out ④ of the camera to the monitor or other video
equipments (DVR) with a 75 ohm cable (RG59).
(4) When using an auto Iris Lens, ensure that the "Electronic shutter
switch ① is "ON" (Iris switch)
(a) If the Lens is DC driven, the "DC/VIDEO" switch ② should be
switched to DC, and the optimal image effect can be achieved
by adjusting the "Level Knob" ⑤.
(b) If the Lens is VIDEO driven, then the switch "DC/VIDEO" ②
should be changed to the VIDEO position.
(5) Plug in the power supply:
(a) Case model B- direct plug is used (DC + in and - out) and after
connecting the plug the "Power Indicator Light" ⑦ will work. At
this point the monitor displays the live image.
(b) Case model D/H- power is connected by two wires. Make sure
you plug the power in the right direction "+" / "-".
(6) Adjust the zoom and the focus of the Lens to get your optimal
image.
(7) Back Focus is adjusted at the factory, therefore there is no need for
further adjustments. However, in case you can't reach optimize
focus by the lens focus ring, untie the "Back Focus Screw", then turn
the "Lens Mount Ring" clockwise or counter clockwise until the
image is clear. Then retighten the "Lens Mount Screw".
Operation Steps
③ On the camera casing
alarm shop