Specifications

ManualsBrandsProvision ManualsHome building and DecorCHALLENGER PRO

System

Setup

What’s User Code

The 2

wire CHALLENGER PRO system, each Monitor installed in system must be programmed with a calling

address or calling number, which is User Code.

For Monitor, User Code is defined by 1~5 bits DIP switchers on the connection board, according the User Code rules.

For example, if you want to program the Monitor’s User Code to be “03”, the Monitor’s 1~5 bit DIP switcher¬s should

be set as: ON, ON, OFF, OFF, OFF(please refer to User Code table at section2

Monitor).

For Door Station, each Call Button on panel is assigned to a specified User Code, and press this button will call

related Monitor. For example, press the call button labled as “03”, system will launch a call to the Monitor which

programmed with “03” User Code.

Note

that the Bit

4 of the DIP switches on the Door Station should be set to OFF

for Double line button Door Station, set to ON for Single line button Door Station.

The User Code array on panels has been pre

defined as below, that’s the default mapping as follow:

Bit-4=off

01 02 09

Bit-4=on

01 05

1 2 3 4 5 6

PROR11-

PROP11-

D24

1 2 3 4 5 6

PROR11-

PROP11-S12 PROP11-S12

However, the User Code mapping of Call Buttons can be changed, so as to meet the need of complex required

installations. To program the Door Station User Code mapping, you have to use CHALLENGER PRO

CONFIG

software to program each Door Station, by editing User Code, and download. Please see related contest for

reference.

For example, when Call button of Guard Center and

Cancel button are needed, User Code mapping may be:

In another installation example, 2 Door Stations are

installed and need to be setup as below:

05 04

03 02

C G

Button C is defined

for Cancel operation

Button G is defined

07 15

13 14

11 12

01 02

07 08

23 31

22 21

01 02

for calling Guard Unit operation

PROR11-D8

1st door station 2nd door station