Specifications
CHALLENGER PRO
-
System
10
JP_LK
JP_LK
JP_LK
2
B. Connection for Power
- -
off
-
to
-
Unlock
type:
-
+
12V 300mA
+12V
LK - (GND)
N.O.
EB+
EB -
DIPS
1 2 3 4 5 6
ON
DIPS-5: set to on,
unlocking time is 5 seconds.
Jumper set to 2-3 position
1
set to Normally Closed on the
3
Unlock Relay mode on
CHALLENGER PRO software.
2. Additional power supply
When the electronic lock is over 12 Vdc, additional power supply for the lock is needed.
• The power supply for the lock must be less than 48Vdc 1.5A.
• The Jumper must be removed when using additional power supply. The default is set for Power
-
to
-
Unlock
type(Normally open), if use Power
-
off
-
to
-
Unlock type, change the Unlock Relay mode to Normally
closed on the Parameter tab of CHALLENGER PRO CONFIG software.
• If different unlocking time is needed to be configured, please use the CHALLENGER PRO CONFIG software to
change the setting on the Parameter tab(see the program section).
C. Connection for Power
-
to
-
Unlock
type:
Note:
Cut off this line when using
additional power supply
+
-
+
-
Remove the Jumper
set to Normally Open on the
Unlock Relay mode.(default)
+12V
LK - (GND)
LK+(COM)
N.O.
EB+
EB -
1
2
3
DIPS
1 2 3 4 5 6
ON
DIPS-5: default set to
off,
unlocking time is 1
second.
(In most cases, 1 second
is
work for
Power-to-Unlock type)
D. Connection for Power
- -
off
-
to
-
Unlock
type:
Note:
Cut off this line when using
additional power supply
+
-
+
-
Remove the Jumper
set to Normally Closed on the
+12V
LK - (GND)
LK+(COM)
N.O.
EB+
EB -
1
2
3
DIPS
1 2 3 4 5 6
ON
DIPS-5: set to on,
unlocking time is 5 seconds.
Unlock Relay mode on CHALLENGER PRO software.