Operation Manual

DVR User Manual

and time (day or night), you can adjust its value according to the practical conditions. Left

click the grid and drag to delete area. Click icon to set the whole area as detection

area. Click icon to clear the set detection area. Click icon to test the sensitivity

as per the local conditions. Once motion is sensed, it displays a figure icon. Click

icon, to save the setting. Click icon to exit the current interface.

Note: Prior to setting motion detection field it is recommended that you click icon

to clear the existing field and set afresh.

⑧ Select “All” to set the same settings for all channels.

⑨ Click “Apply” button to save the setting.

⑩ Go to Schedule tab. The setting steps for schedule for motion based alarm are similar to

normal schedule setup (see Chapter 4.4.1 for more details).

5.5.2 Video Loss

This DVR can be set up to detect video loss. The setting steps are as follows:

① Go to Main MenuSetupAlarm Video Loss. Refer to Fig 4-20.

② The setup steps of video loss trigger are similar to motion trigger setting. (See Chapter

4.5.1 MotionTrigger setting for more details).

Fig 4-20 Alarm Configuration-Video Loss

5.5.3 Other Alarm

This tab gives a choice to configure alarm for Disk Full, IP Conflict, the Disconnect event, Disk

Attenuation or Disk Lost.

① Go to Main MenuSetupAlarmOther Alarm. Refer to Fig 4-21.

② Use the dropdown menu and select the event or the alarm.

③ Check the required trigger options.

④ If the selected event is “Disk Full”, then use the drop down box for “Disk Shortage Alarm”

to choose a threshold value for remaining HDD space. If the threshold value is reached,