Operation Manual
DVR User Manual
20
5.3.3 Time
① Go to Main MenuSetupRecordTime interface to set recording time. Refer to Fig 4-
13.
② Set Pre-alarm record time and post-alarm record time. Select “All” to set the same settings
for all channels.
Pre-alarm Record Time: Set the time in seconds to pre-record before the actual recording
begins.
Post-alarm Record Time: Set the time in seconds to post-record after the actual recording
has finished, five options: 10s, 15s, 20s, 30s, 60s, 120s, 180s and 300s.
Expire Time: Set the expiration time for recorded video. If the set date is overdue, the
recorded files will be deleted automatically.
③ Click “Apply” to save the setting.
Fig 4-13 Record Configuration-Time
5.3.4 Stamp
This provides an option to enable or disable the Camera Name and the Time stamp on the video.
The user can also choose a position for the stamp on the screen.
To set up stamp as follows:
① Go to Main MenuSetupRecordStamp interface. Refer to Fig 4-14.
Parameter
Meaning
Rate
720P: 1-15（NTSC）/1-12(PAL); 960H: 1-30（NTSC）/1-25(PAL).
Resolution
This series supports 720P, 960H.
Quality
The higher the value is, the clearer the recorded image is. Six options:
lowest, lower, low, medium, higher and highest.
Encode
VBR and CBR.
Max bit stream
You shall adjust it subject to the actual network condition.